Hi, Welcome to our website.
24h*7 Hotline
0755-29941300 13823711712

Contact us

Address: Third Industrial Zone, New Komeito Village Shenzhen Guangming 26
Postal Code: 518000
Tel: 0755-29941300
Fax: 0755-27123802
E-mail: 653088031@qq.com
Mobile: 13600187830

Details

Site: Home > News > Industry News > Details

What should be paid attention to when using the rolling gate equipment?

Time: 2022-06-30 View: 782
What should I pay attention to when using the rolling gate equipment?


A. Before the rolling gate equipment is started, fill the gearbox with enough oil, and fill the hydraulic station with 60 hydraulic oil


B. Adjustment of the feeding of the rolling gate equipment: before work, correct and correct the appropriate materials on the guide plate. If the extruded materials have left and right deviation, resulting in tripping, shake them left and right at the feeding position of the feeding guide plate until the extruded products are suitable, and then tighten the screws.


C. Before starting the rolling mill, the rolling gate equipment shall add lubricating oil at the upper and lower rolling wheels of the gear, otherwise the gear and rolling wheel will be damaged due to friction. During the mechanical operation of the rolling shutter door, the rolling wheel shall be lubricated every hour, the gear every eight hours, and the reducer every half a year to maintain the rolling shutter door machinery.


D. Mechanical straightening and leveling of rolling gate: if the product is not straight and uneven after coming out, it should be adjusted on the straightener. First, straighten the lower rolling wheel to the position of forming a parallel line with the forming rolling wheel, and then roll the upper rolling wheel downward to see if the rolled material is parallel. If not, adjust the straightening rolling wheel up and down to parallel. If there is a left-right swing bend, it should be corrected with the left-right screws at the outlet of the straightener.


E. Adjustment of rolling wheel of rolling gate equipment: after the rolling mill starts, push the material into the first group of rolling wheels. When the material enters the last two groups of rolling wheels, pay attention to whether the product meets the shape requirements. Adjust the adjusting screw up or down to the required requirements before tightening the adjusting screw.


F. Mechanical cutting machine for rolling gate: the positioning pliers of the cutting machine, the rolled products and the positioning ruler shall be leveled, and the positioning iron shall be corrected and fixed according to the required length.
Service Online Miss shiManager Li
Hotline
  • 0755-29941300
  • 13823711712