Dongguan Huangjiang garage door motor replacement - Dongguan electric garage door replacement price consultation
Time: 2020-02-10 View: 1508
Dongguan Huangjiang garage door motor replacement - Dongguan electric garage door replacement price consultation
The car in the garage is a relatively expensive property for ordinary people, so the safety performance of the garage door is very important. In order to ensure the safety and cost performance of villa garage doors, many garage doors will choose to install anti-theft and anti-theft system. When the system facilities encounter sudden impact, it can make the door body stop automatically when it is impacted by the outside, so as to protect the safety of people and vehicles entering and leaving, as well as the reliable use of the door. Another security system is the infrared sensor control system. When someone, vehicle or pet enters the garage, the infrared sensor will automatically send out a signal, and automatically install the garage door to ensure safety. The anti-theft alarm system can be reinstalled. When someone Prys the door, the alarm system´s tweeter will give an alarm to remind someone to move the door to protect the property.
Place the chain box in the correct position on the adapter sleeve.
Press the chain box gently on the motor.
Note: do not use too much power. If the chain box is parallel to the motor surface, simply pull the guide slide to drop the chain box onto the door opener.
Tighten the chain case and motor with two clips and four hex screws.
Determine the space position of chain box
The installation of transmission parts shall be installed in the middle of the door as far as possible to determine the space position of the chain box: slowly open the door body upward, and check the approximate position command point. When the top panel of the door passes through the opening, it corresponds to the vertical direction + 150 mm to 250 mm above the door hole positioning guide rail rear bracket.
Install the rear fixing bracket
After confirming the installation position, fix the bracket with the screws in the accessory package.
Hang the chain box on the rear fixing bracket, and fix the rear part of the drive part on the rear fixing bracket with bolts. (pay attention to the cleaning cushion under the driver´s head to protect the surface of the driver´s head from being scratched. )
Determine the fixed position of the drive
Drive the head to swing to the ceiling, find the fixed head position on the ceiling, mark with pencil, and then install the fixed bracket.
A car with suspension
Fix the fixing plate on the top of the door opener, and bend the fixing plate properly according to different installation positions.
