What should be paid attention to when installing the electric door track

Because there are many types of electric doors and their sizes are different, it is impossible for professional installers to complete them. Let´s take the rail installation of electric door as an example to make a detailed description, which is divided into two types: trackless door and rail door, so that customers can have a deep understanding.


Installation of trackless door


1. When installing the complete trackless, measure the size on the center line according to the installation size of the magnet and mark the line;


2. Drill the positioning hole with a small impact drill bit (pay attention not to deviate);


3. After drilling the positioning hole, use the same number of magnet drill to enlarge the hole position, and deepen it to a slightly deeper height than the magnet;


4. Put water into the hole first, and then fill it with cement;


5. Place magnets in accordance with the same consistency in order (the magnets should be level with the ground, not higher than the ground, and the excess cement should be removed).


Installation of rail door


1. Measure the position of the double track on both sides of the center line (the single track is subject to the center line). Refer to the attached installation method for the electric door track.


2. Use the ink bucket to pop up the double-track track line (the single track is subject to the center line)


3. Use the ground laying machine to separate the ground from the depth of the embedded track (according to the installation dimension drawing or customer requirements)


4. Put the rail into place and fix the edge with the pop screw, and weld it with the welding machine (note that the plane of the rail should not be bent or deformed.)


5. Fill the track edge with cement sand. (The angle wheel rail shall be filled with cement sand and then fixed in the angle iron)


6. When embedding the track without the ground, pay attention to the level of the track and the wheelbase on both sides (the track wheel shall reserve the walking groove on both sides of the track).


7. Refer to the installation method and dimension diagram of the magnet after the installation management of the limit magnet.


8. Put the door row into the track (for the electric door with the windproof card, remove the windproof card first, then put the door row into the track and then install it back), push the door row manually, and check whether the door row and the track are stuck with the bottom beam and run out of the track.


The above steps are required to be mastered during the installation of the electric door track. Any failure will affect the later use of the electric door, and some will derail.