What daily inspection work should be done for the induction automatic door

In order to ensure the safe and reliable operation of the automatic door, the user or the automatic door manager should carry out the necessary operation inspection on the automatic door on a daily basis, and the test inspection should be carried out without the interference of other personnel.

Personnel move towards the automatic door from outside or inside the door at normal speed. The automatic door should open automatically. The action of the automatic door should be smooth and there should be no collision; After the automatic door is opened, the automatic door should remain open when the personnel slowly pass through the automatic door at a speed of about 150mm-200mm per second; When a person leaves the sensing area of the automatic door sensor, after a delay of 1-10 seconds (the length of time can be set by the automatic door switch parameters), the automatic door will automatically close, and the action of the automatic door should be smooth and there is no collision;

Observe the normal walking route of the personnel through the automatic door. It is necessary to adjust the daily walking route to that the personnel are facing towards the automatic door, rather than walking towards the automatic door at a certain angle. When walking towards the automatic door, the sensing width range of the automatic door sensor should be greater than the width of the fully opened door;

If the automatic door is equipped with an auxiliary light sensor (infrared radiation protection device), when the door is opened, people stand still and block the auxiliary light sensor with their hands, the door should remain open. The door should be closed again within a few seconds after the hands leave.